Pressure Switches

MDS Series Pressure Switches are recommended where to measure pressure difference between two points in a single system & controls accordingly.

Note : Equivalent or B4 Series of Indfos, GM Series of Switzer & Z series of Waaree

Enclosure	Aluminum Die Cast Weather Proof to IP-66
Sensing Element	Diaphragm Sealed ( up to 40 bar ) / Piston type above 60 bar
Wetted parts	S S 304 / S S 316
Repeatability	± 1 % of Full Span
Scale Accuracy	± 3 % of Full Span
Micro Switch	1 SPDT Snap Action or 2 SPDT on request
Switch Rating	15 A, 250 V AC or 0.2 A, 220 V DC / Varies based on selection of Micro Switch
Range	Refer Standard Range Table
Set point	Between 20 to 80% for better performance
Over Protection	150 % of Full Span
Differential	Fixed / Adjustable
Mounting	Bottom / Panel
Process connection	¼” NPT (F)
Set Point adjustment	External with Locking system
Cable entry	PG 13.5mm Standard / DIN Connector or Other optional
Maximum Process Temperature	150° C / 300° F
Conformity	BS 6134 Standard
High voltage strength	0.5 to 0.6 KV between open contact 2 KV between contact & Body.
Insulation resistance	> 10 M ohms at 500 V
Process Media	Air, water, Oil etc….
DP Chamber	Aluminum for Range 5 to 600 mbar S S 316 for Range 1 to 25 bar

Name *

Email *

Your Message